| Power Source | ・Power-over-Ethernet (PoE): class 2 (low power, ≤6.49 watts)
|
|---|
| Network Audio Technology
| ・Type: Dante audio-over-Ethernet
・AES67-2013 Support: yes
・Dante Domain Manager (DDM) Support: yes
・Bit Depth: up to 24
・Sample Rate: 44.1 and 48 kHz
・Number of Transmitter (Output) Channels: 4 (main, talkback 1, talkback 2, talkback 3)
・Number of Receiver (Input) Channels: 4 (Headphone Ch1, Headphone Ch2, Headphone Ch3, Headphone Ch4)
・Dante Audio Flows: 4; 2 transmitter, 2 receiver |
|---|
| Network Interface | ・Type: 100BASE-TX, twisted-pair Ethernet, Power-over-Ethernet (PoE) supported
・Data Rate: 100 Mb/s (10 Mb/s and 1000 Mb/s "GigE" Ethernet not supported) |
|---|
| Microphone Input | ・Compatibility: dynamic or phantom-powered microphones
・Type: balanced, capacitive coupled
・Impedance: 2 k ohms, nominal
・Gain: 35, 43, 52, 59 dB, selectable
・Frequency Response: 25 Hz to 20 kHz, -3 dB
・Distortion (THD+N): <0.022%, measured at 35 dB of gain
・Dynamic Range: 96 dB, A-weighted
・Phantom Power: P48 per IEC 61938 standard, on/off selectable with status LED |
|---|
| Compressor | ・Application: applies to Dante main and talkback transmitter (output) channels
・Threshold: 1 dB above nominal level (-19 dBFS)
・Slope: 2:1
・Status LED: compressor active |
|---|
| Microphone Output | ・Type: passive via two 200 ohm resistors from
・microphone input (will pass phantom power in either direction)
・Muting: solid-state relay contacts, 60 dB attenuation @ 1 kHz |
|---|
| Headphone Output | ・Type: 2-channel (stereo)
・Compatibility: intended for connection to stereo (dual-channel) or monaural (single-channel) headphones, headsets, or earpieces with nominal impedance of 50 ohms or greater
・Maximum Output Voltage: 3.8 Vrms, 1 kHz, 150 ohm load
・Frequency Response: 20 Hz to 20 kHz, -2 dB
・Distortion (THD+N): <0.002%
・Dynamic Range: >100 dB
|
|---|
| Remote Control Inputs: 2 | ・Functions: configurable to mimic the action of the main, talkback 1, talkback 2, or talkback 3 button functions
・Type: active low, 1 mA maximum, inputs pull up to 3.3 volts DC |
|---|
| Connectors | ・Microphone Input: 3-pin female XLR
・Microphone Output: 3-pin male XLR
・Headphone Output: 3-conductor ・inch jack
・Remote Control Inputs: 3-conductor 3.5 mm jack
・Ethernet: Neutrik etherCON RJ45
・USB: type A receptacle (located inside Model 206's enclosure and used only for updating firmware)
|
|---|
| Configuration | ・requires Studio Technologies STcontroller personal computer application, version 1.05.00 and later (STcontroller compatible with WindowsR version 7 and later) |
|---|
| Dimensions (Overall) | ・4.3 inches wide (10.9 cm)
・2.1 inches high (5.4 cm)
・5.1 inches deep (13.0 cm)
|
|---|
| Deployment | ・intended for tabletop applications
|
|---|
| Weight | ・1.2 pounds (0.55 kg) |
|---|
スタッフコメント