*予定納期について:お取り寄せ商品の予定納期は、おおよその目安として表記しております。出来る限り最新の情報を掲載しておりますが、メーカーの在庫状況によってはお届けまでお時間を頂く場合もございます。ご了承ください。
676は、デジタル化された製作環境で失われがちな、太く温かみのある音質を再生します。プリアンプ部に250V駆動の双三極管12AU7/ECC82を搭載。真空管への入力ゲインを最大+60dBまで調整でき、ニュートラルなクリーントーンから倍音成分に富んだ温かみのあるサウンドまで自在に作ることができます。また、真空管の後段にレベルを調整できるアッテネーションつまみを装備しています。
676は、定評あるdbxのイコライザー、コンプレッサー/リミッターを搭載しています。イコライザーは中帯域がスイープ可能な3バンドのパラメトリックイコライザーを採用。マイクロホンによるサウンドのクセなどを補正できます。
コンプレッサーは、dbxの名機162SLの設計を継承。アタック/リリース時間を自動または手動で設定が可能なうえ、ニー特性を滑らかにするOverEasyスイッチも搭載しています。リミッターは過大入力からシステムを保護すると同時にダイナミックレンジを最大化するPeakPlusを採用しています。
676は、用途に応じて便利に使用できる入出力端子を装備しています。入力にはXLR端子のマイクロホン入力以外に、標準フォーンジャックの楽器入力を用意。エレキギターなどのハイ・インピーダンスの楽器を直接接続できます。
出力はコンプレッサー/リミッター後のライン出力のほか、EQ後コンプレッサー前の信号を取出せるプリアンプ出力も用意。どちらもXLR端子と標準フォーンジャックの2種類を装備しています。さらに、ポストプリアンプにインサート端子、コンプレッサーにはサイドチェイン端子を備え、外部プロセッサーの拡張に使用できます。
前面パネルには、入力/出力/ゲインリダクションを切替えて表示するビンテージVUメーターを装備。また、20dBのパッド、+48Vのファンタム電源、極性の反転スイッチ、80Hzのローカットフィルターも搭載しています。
製品仕様 | |
---|---|
スペック | Mic Preamp Connector:Female XLR Pin 2 Hot; Electronically balanced/unbalanced Mic Preamp Input Impedance :1.9 kΩ CMRR >85 dB from 20 Hz to 3 kHz, >70 dB from 3 kHz to 20 kHz Instrument Input Connector Tip-Sleeve ¼” Jack Input Type :(instrument) Unbalanced Instrument Input Impedance 500 k Ω Max Input :(instrument) +21dBu unbalanced Preamp Insert Connector :Tip-Ring-Sleeve ¼”, RF filtered Preamp Insert Type :Unbalanced, Tip = send, Ring = return Line Outputs (Preamp & Compressor/Limiter) Connector Male XLR and Tip-Ring-Sleeve ¼” (Pin 2 and Tip hot) Line Outputs (Preamp & Compressor/Limiter) Type Servo-balanced/unbalanced Line Outputs (Preamp & Compressor/Limiter) Impedance Balanced 30 Ω, unbalanced 15 Ω Line Outputs (Preamp & Compressor/Limiter) Maximum Output Level > +21 dBm (into a 600 ohm load) Compressor Sidechain Insert Connector :Tip-Ring-Sleeve ¼”, RF filtered Compressor Sidechain Insert Type :Unbalanced, Ring = output, Tip = input Compressor Sidechain Insert Impedance :1 kΩ (output), 50 kΩ (input) Vacuum Tube Type :12AU7A / ECC82 Vacuum Tube Grid Power Supply :+250V DC Vacuum Tube Heater Power Supply +12V DC Frequency Response (Mic Input) :20 Hz to 50 kHz, +0/-1dB, 40 dB gain Frequency Response (Instrument Input) :30 Hz to 70 kHz, +0/-1dB, unity gain THD + Noise (Mic In to LIne Out) :0.25% typical at 0 dBu out, 1 kHz, 40 dB gain THD + Noise (Instrument In to Line Out) :0.2% typical at 0 dBu out, 1kHz, unity gain Equivalent Noise Level :Typically > -123 dBu with a 150 Ω source load, 22 Hz to 22 kHz Noise Floor :Mic Insert to Comp Output: <-93 dBu, unity gain, EQ flat and no gain reduction Preamp Function Switches/Controls: Instrument Input :Selects between microphone XLR input and front panel ¼” instrument input Preamp Function Switches/Controls: +48V Sends +48 VDC through 6.81 kΩ resistors to pins 2 and 3 of the microphone input Preamp Function Switches/Controls: 20dB Pad Attenuates the microphone input by 20 dB Preamp Function Switches/Controls: Polarity Invert :Reverses pins 2 and 3 of the microphone input XLR Preamp Function Switches/Controls: 80 Hz Low Cut :Enables an 80 Hz, 12 dB/octave high pass filter in the microphone and instrument signal path Preamp Function Switches/Controls: Gain Control Range -∞ to +55 dB for Microphone Input; -∞ to +40 dB for Instrument Input Preamp Function Switches/Controls: Post Tube Attenuation -∞ to 0 dB Preamp Function Switches/Controls: Peak Indicator :Illuminates RED when the Preamp is within 3 dB of clipping EQ Low Frequency :100 Hz, Low-pass shelving filter EQ High Frequency :10 kHz, High-pass shelving filter EQ Mid Frequency :Sweepable from 100 Hz to 8 kHz EQ Function Switches/Controls: Narrow :Selects the “Q” of the MID Frequency EQ. “OUT” position Q = 0.9; “IN” position Q = 2.9r/> EQ Gain :(All Bands) Sweepable from –15 to +15 dB Compressor Threshold Range :-40 dBu to +20 dBu Compressor Threshold Characteristic :Selectable OverEasy™ or Hard Knee Compressor Ratio :Variable 1:1 to ∞:1; 60 dB maximum Compression Compressor Attack/Release Modes Selectable Manual or Auto Compressor Manual Attack Time :Scalable program-dependent; Typically 400 dB/msec to 1 dB/msec Compressor Manual Release Time :Scalable program-dependent; Typically 4000 dB/sec to 10 dB/sec Compressor Auto Attack Time :Program-dependent, typically 15 ms for 10 dB, 5 ms for 20 dB, 3 ms for 30 dB Compressor Auto Release Time :Program-dependent, typically 120 dB/sec Compressor Output Level Control Range :-20 dB to +20 dB Compressor Peak Indicator :Illuminates RED when the Compressor/Limiter is within 3 dB of clipping Limiter Type dbx PeakPlus™ Limiter Threshold Range :-4 dBu to + 22 dBu (off) Limiter Ratio ∞:1 Limiter Attack and Release :Program-dependent Power Supply Universal switch-mode Operating Voltage :100 – 240 VAC, 50/60 Hz Power Requirements 20 Watts Fuse T2.5AL 250V Turn-On Time Approximately 2 seconds |
寸法 | 3.5”H X 19”W X 8”D (88.9mmH X 482.6mmW X 203.2mmD) |
重量 | Weight 8.1 lbs (3.7 kg) Shipping Weight 11.0 lbs (5.0 kg) |